Light the bulb with your fingers

Pin
Send
Share
Send


Good day. In this article I will tell you how to make an interesting trick and surprise your friends. The focus is quite simple, but it will require you to make a certain device - a light bulb.
For this we need:
Two matte bulbs, absolutely any size. We also need a lighter with a flashlight and a couple of small wires.

After everything is prepared, we proceed to production.
We isolate the base and the bulb from the bulb, solder one wire to the base of the base and the other to the very bottom of the base, separated by insulation.

We put out a flashlight from the lighter, and solder the end of the wire from the base of the cap to the plus to the batteries of the flashlight, and the other, from the bottom of the cap to the minus of the LED.

To light the LED, we need to close the circuit, for this we cut one of the small wires from the wire, soldering one end to the case, and the second end - bend along the insulation on the base.

To make the light come on, we quietly shift the wire with your finger, closing the chain. It remains to glue the flask to the cap, and you can go amaze your friends.

The manufacturing process on video:

Pin
Send
Share
Send

Watch the video: How to make a amazing bulb light on to your finger (March 2024).