Dragonfly

A dragonfly made in the modular origami technique is quite simple. Making it will take a little time, but you can decorate the interior with a beautiful bright figure. If all the triangular particles are glued together, then the dragonfly can be used as a toy.
For the manufacture of dragonflies, you need 63 triangular modules: 8 red, 16 yellow, 7 green and 32 blue.
The body consists of 19 modules: 8 red and 11 yellow. First you need to connect 2 modules, putting the pockets on top of each other. It will take 2 such blanks.
Using the three yellow modules, the red blanks must be connected. Modules should also be worn with the long side.
In the free side yellow pockets you need to insert one more yellow module. In the future, dragonfly wings will be attached here.
The fourth row will consist of two red modules. They need to be worn with the long side.
The fifth row consists of three yellow modules. The difference here is that in the yellow pockets you need to hide not only the red modules of the previous row, but also the protruding yellow corners of the third row. Again, one yellow module must be inserted into the side pockets of the yellow modules. A second pair of wings will be attached here.
The sixth row includes 2 red modules, moreover, they need to evenly capture all the corners of the previous row.
In conclusion, the manufacture of the body of a dragonfly you need to wear 1 yellow module in the middle.
To make one dragonfly wing, you need 8 blue modules. Each module must be inserted with one corner into a corresponding pocket.
The last module, which will be attached to the body, must be inserted into two pockets.
According to this principle, you need to collect two right wings and two left.
The tail will consist of 5 green and 5 yellow modules. Alternating them, you need to insert them with two corners in 2 pockets. At the end, the tail should be slightly bent.
Mustache is very simple to make from two green modules. They need to be wound on a pencil or pen, so that they become rounded.
When all the components are ready, you should start assembling the dragonfly.
Suitable wings must be worn on the holders. Then, attach the tail, hiding in it all the free 4 corners. Mustache should be inserted into the modules of the first row.
Bright beautiful dragonfly from triangular modules is ready!
The colors of the modules can be changed, chosen to your liking. Dragonflies made in different color combinations will look very nice.