DOTTED SUMMER BUTTERFLY

Send

For the manufacture of decorative plates in dot painting, we need such materials:
1. A plastic plate.
2. Acrylic contours and glitters of different colors.
3. Sketch drawing.
4. Acrylic paints (white and black colors).
5. PVA glue.
6. Alcohol.
7. Varnish for coating an acrylic base.
8. Sponge for paint.
9. Napkins made of paper.
10. The middle brush.
11. Colored pencil.

Work begins with surface degreasing with alcohol. This is done so that the paint falls flat on the plate. Wipe with alcohol on both sides.

Next, the entire product must be greased with a small layer of PVA glue. These actions are performed with the aim of better adhesion of the paint to the treated surface.

Then, using a sponge, paint the plate with white acrylic paint. To do this, sponges are made to press against the product movement. Using a sponge, we avoid brush marks, and the surface is painted evenly. You can use not only decorative, but also building acrylic paint. It must be applied on both sides.

We apply white paint for the purpose of priming the surface. After the first layer, the picture under the plate is visible, so we paint over it again.

Next, we cover the product on both sides with acrylic varnish. Thus, we fix our soil and protect the surface from bloating.

The next step is to prepare the background of the plate. To do this, apply two layers of black acrylic paint to the entire product with drying between staining.

Then the plate must be treated with acrylic varnish. This is done to fix the paint, and also if we put a sloppy point, then it can be removed without damaging the surface. Using glossy varnish, we will add gloss to the surface.

After drying the product, you can begin to apply the drawing. To do this, decorate the reverse side of the sketch with colored pencil. Take bright colors so that they can be seen on a black background.

Next, apply the pattern with the butterfly on the plate, face up. And we begin to circle the sketch, pressing hard on the pencil. When we remove the drawing, we will see how our butterfly transferred to the product.

Proceed to painting the plates. To do this, take a contour for painting and outline the silhouette of a butterfly.

Now take the contours or glitters and apply the main big points.

We continue to highlight the main lines of the butterfly.

Proceed to painting the wings. You need to work carefully so as not to catch the points already put down.

So fill the two upper wings.

We pass to the two lower wings. The size of the point to be left depends on the pressure applied to the tube. For a large point, you should press on the circuit harder, for a small one - easier.